Road Construction Report(s)

9/20/12 Damen from Division to Jackson is "Rough Grooved Surface." Plan accordingly.

Views: 11234

▶ Reply to This

Replies to This Discussion

Permalink Reply by Lisa Curcio on October 30, 2015 at 6:34am

There is green thermoplastic in the bike lane on Washington east and west of Clark!

Permalink Reply by Maurice on October 30, 2015 at 9:20am

I've been closely watching the progress of those lanes, and I still have no idea what they intend to do between Franklin and Clinton.  An obvious step would be to add plates to the bridges.

Permalink Reply by Lisa Curcio on November 5, 2015 at 1:27pm

The repaving of Elston north of North Avenue appears to be underway.  Pavement in strips of "rough grooved surface".   Not a good place to ride right now, though.  Posted signs say no parking 11-5-2015 to 12-19-2015.

Permalink Reply by Rich S on November 5, 2015 at 2:09pm
Yup, Elston from North Ave all the way to Webster is really bad. Avoid that stretch if you can.
Permalink Reply by David P. on November 6, 2015 at 6:53am

My office is off of Elston near the Home Depot, and I will be very glad to finally have non-shitty pavement here.

Permalink Reply by JeffB on November 12, 2015 at 6:19am

Yeah, this was one of the areas most in need of repaving. Hopefully we'll get good lane markings on northbound Elston at Ashland

Permalink Reply by Rich S on November 12, 2015 at 6:41am

Yeah that whole stretch between Cortland and Ashland is a mess. We need proper bike lane markings since drivers always turn that bit into two lanes. The right turn onto northbound Ashland should have 2 right turn lanes and 1 lane to proceed northwest on Elston. Elston really doesn't need 2 northbound lanes on that 40 foot stretch between Armitage and Ashland. 

Permalink Reply by Cheryl on December 2, 2015 at 4:33am

Absolutely agree with this. Ideally, a bike-specific light would be added to allow bikes to proceed north on Elston without motor vehicle traffic moving at the same time to really reduce the danger of vehicles cutting over through the bike lane.

Permalink Reply by David P. on November 20, 2015 at 9:02pm
Paving crews were hustling today (Friday) to get a layer of asphalt onto Elston before the weather arrived. Not done yet, but not such a rodeo to ride any more.
Permalink Reply by JeffB on December 1, 2015 at 6:33am

They were still paving yesterday, but the right lanes in both directions were done. So much better to ride that stretch now. Wonder how long the lane markings will take.

Permalink Reply by Tandemonium on December 1, 2015 at 2:14pm

Elston paving is complete. Center lane markings installed in some locations, still no bike lane markings which is tempting motorists to make it a 4 lane road.

More interestingly, it seems that they are redoing the lanes at the Armitage intersection to force motorists to choose either Elston or Ashland North of the intersection. This should reduce the amount of people taking a right from the Elston through lane, greatly improving the intersection for cyclists.

Permalink Reply by Rich S on December 1, 2015 at 4:49pm

Smooth as silk riding home from class tonight! But without those lane markings I wouldn't dare ride Elston between North and Ashland during evening rush hour. With the parking restriction leaving the right lane open I can't imagine it would be safe. 

I'm interested to see how they handle the intersection with Ashland since that's never a fun one to ride through especially going north. 

RSS

Groups

© 2008-2016   The Chainlink Community, L.L.C.   Powered by

Disclaimer  |  Report an Issue  |  Terms of Service