I snapped a brazed-on eyelet from my rear dropout, and my four-point rack attachment has been reduced to three. The frame is steel. I'm assuming I can get someone to weld on a new eyelet. Do I need a frame builder or is there a preferred welder out there? Any recommendations would be greatly appreciated.

Views: 47

Reply to This

Replies to This Discussion

Try Owen at Blue City Cycles. Not sure if he is doing this anymore, but he would definitely know someone who could.
I have a number for Owen (assuming there's only one Owen frame builder in Chicago), if you email me, I'll send it to you. marqone at excite dot com (and that's a Q, not a G).

If you don't want to spend the money, you could just use a p-clamp, ask at your LBS.
Thanks for the referral. Owen's the guy.

RSS

© 2008-2016   The Chainlink Community, L.L.C.   Powered by

Disclaimer  |  Report an Issue  |  Terms of Service