Replies to This Discussion

Permalink Reply by SlyRed on September 17, 2011 at 12:48am

The wheelset:  Basically the same wheelset I built for Blackadder, except the front hub does not have the dyno.  Sun CR18 rims, 700c, black, 36 hole.  Front hub, Sturmey Archer X-FD. rear hub, Sturmey Archer X-RD3.  Sapim Race spokes, double-butted stainless steel.

 

Here's a picture of part of the spoke set prepped as was taught to me by my esteemed wheel building teacher, Christopher Wallace.

Permalink Reply by SlyRed on September 17, 2011 at 7:29am

Wheelset is laced and tensioned, but needs to be stressed and re-trued.  I gave them a preliminary fit on the frame today.

 

Permalink Reply by SlyRed on September 18, 2011 at 10:16pm

The frame is going to Owen Lloyd soon to have certain braze ons removed and pump pegs added.  While it's there it'll get powdercoated in black.  I need to check my inventory of decals and order what I need from Cyclomondo.

Permalink Reply by SlyRed on October 9, 2011 at 12:20am

I've received the Lauterwasser handlebars, the Brooks grips, Origin8 ProPulsion brake levers and Sturmey Archer three speed shifter.  Here's a picture of them assembled with the stem (Nitto Technomic 50mm)

Permalink Reply by SlyRed on November 13, 2011 at 11:33pm

The frame is back from the powdercoater.  I've attached the headbadge and pressed on the crown race.  I also applied some of the frame decals.  Before full fledged asssemby starts I've got to tape off the seat tube and paint the decorative stripes.  Owen Lloyd did a great job brazing on the pump pegs and removing other unnecessary cable guides.

Permalink Reply by SlyRed on November 25, 2011 at 11:55pm

The frame and fork are all ready for assembly.  Except for a few non-essential parts the bike is ready to be built.  If you'd like to be involved in the build get in touch with me through The Chainlink.  Those of you who have already responded, I'll see you on December 3rd in Arlington Heights.