Pedal Bearings: Regreasing and Repacking

I was going to post this in the barter/share/trade thread, but that doesn't always get a lot of views. 

I was watching a dude on youtube do it, and while it seems fairly straight-forward, I'm slightly afraid I'd mess up. Is there anyone who'd be willing to do it for some beer and a little cash? It's only my one pedal that's getting gummed up so it'd be fairly quick (the dude on youtube did a whole walkthrough and process in less than 20 min, I think.

Views: 136

▶ Reply to This

Replies to This Discussion

Permalink Reply by S on July 19, 2012 at 12:53pm

What type of pedals do you have?  The procedure and tools needed will depend on what type of pedal is involved.  If your pedal uses cartridge bearings, it'll probably be easier to pop them out and put in new cartridges.

Permalink Reply by Lanterne Rouge on July 19, 2012 at 1:19pm

They're wellgo (I think) SPD pedals. I'm not even sure what type of bearing they use.

Permalink Reply by Andrew on July 19, 2012 at 1:22pm

Have you thought about doing this at one of West Town Bikes' open shop sessions?  Your $10 donation to a very worthwhile organization will get you a stand for an hour, access to any tool you could possibly need, and a little guidance if needed.

RSS

Groups

© 2008-2016   The Chainlink Community, L.L.C.   Powered by

Disclaimer  |  Report an Issue  |  Terms of Service