broke my Sidi's

also dont have reg pedals...this sucks....i noticed one of the bolts/skrews was comming loose...so i went to tighten it back in...turns out it was just broke..the fitting that it skrews in to snapped off...sucks...there the sidi bullet 2's....any one else ever have this problem...on and the other skrew is stripped so i can move it to the other fittings. lame sauce.

Views: 146

▶ Reply to This

Replies to This Discussion

Permalink Reply by Ali on May 19, 2009 at 8:38am
I am totally at a loss here too...

-Ali

grayson said:
You broke the screw for the cleat?
Permalink Reply by Anne on May 19, 2009 at 9:46am
It should be possible to put in a new bolt plate. you have to cut thru the sole from the inside of the shoe to open the "trapdoor". It's easier to do than to type out describing!
Permalink Reply by joe on May 19, 2009 at 12:05pm
yeah...the part of the plate that has the fitting for the skrew broke off.
Permalink Reply by alex on May 19, 2009 at 5:09pm
wtf? How do you always manage to break your shit?

joe said:
yeah...the part of the plate that has the fitting for the skrew broke off.
Permalink Reply by Eric Miller on May 20, 2009 at 3:31am
Bah. You don't need to worry, just let me know where you need to go and I'll tow you there!
Permalink Reply by Jonathan Ortony on May 20, 2009 at 9:50am
Those shoes sound broke, Bullet 2 must have lots of miles too. Your options are... drill it out and epoxy a new screw in, drill it out and bolt the cleat on (you might need to drill a recess for the bolt head/nut), buy some new shoes, buy some used shoes, epoxy your cleats to your feet, get regular pedals.... If none of those sound good, I could sell you some genius or maybe dominator 4/5's which only need strap replacements (45-46 euro).
Permalink Reply by Brett Ratner on May 20, 2009 at 5:22pm
You need a torque wrench, my friend.

Prior to owning a torque wrench, I laid waste to every bolt I ever put a wrench to. I left a trail of stripped threads a mile long. It was embarrassing (and expensive).

I own different shoes and pedals than you do, but my cleats only require 2.5 Newton Meters (or 22 Inch Pounds) of torque to bolt to the shoe. That's not a lot. My guess is that your cleats require a similar torque.

Most bike gear has torque specs nowadays, which is nice because you never have to worry about over tightening or under tightening anything.

Also, a lot of component companies recommend using a grease on the threads to prevent corrosion, binding and such.

I've been using Phil Wood grease, but I'd ask a good bike mechanic what to use.
Permalink Reply by joe on May 20, 2009 at 8:14pm
ehhh...i bought the shoes....lets think..or i i will...about a year ago this july...i wore them thru the winter as well...miles im not sure of...alot tho. i ride a min of 8 miles a day no matter what the weather is...just for work...and alot lot more then that for giggles. the peice that is stuck on the bolt is indeed rusted and stupid.... . im gonna call sidi fa sure and ask them y shit is rusting. the other fittings dont seem to look rusted. so its from the bolt.. and thats dumb and my fault prolly. what ever. thanks for all the advice.

and today i also got my BB replaced....so im super happy. supppper.

RSS

Groups

© 2008-2016   The Chainlink Community, L.L.C.   Powered by

Disclaimer  |  Report an Issue  |  Terms of Service