F*CK $H!T D@mn! My Kryp-Lock Is Rusted Shut

I had one of those Kryptonite Forgettaboutit chain locks, the big one, and the moisture in the storage room has rusted the damn thing shut. Any tips on getting my chain back?

Views: 1783

▶ Reply to This

Replies to This Discussion

Permalink Reply by Matthew on May 6, 2011 at 8:41am

WD-40 is great at loosening rust. Unload a can into the lock and wait a little while (have a beer, you'll feel better). If that still doesn't work, do it like the tieves: grab an angle grinder, some sleeves, and a mask, and go to town. It will take a while, but it's supposed to.

 

I'd be shocked if WD-40 didn't unsieze it though.

Permalink Reply by Jeff Blumenthal on May 6, 2011 at 8:54am
WD-40 or go to an auto store and they will have a rust solution much like 3 in 1 oil.
Permalink Reply by Barry Niel Stuart on May 6, 2011 at 9:19am
Have you tried Liquid Wrench yet?  I've seen it do wonders at loosening up nuts that are rusted onto their bolts. 
Permalink Reply by Spencer "Thunderball" Thayer! on May 6, 2011 at 9:31am
I will try liquid wrench. I've tried the WD40 angle. Thanks! I'll report back this weekend.
Permalink Reply by mindfrieze on May 6, 2011 at 10:05am
Nothing beats PB Blaster.  Liquid Wrench would be my next option; then WD40.  Whatever you use, give it a little time to soak before trying to break it loose.
Permalink Reply by Tank-Ridin' Ryan on May 6, 2011 at 10:20am

Spencer, you must really love cigars to have a humidor big enough to store bikes in it.  Or is that your rain forest reclamation/bike room?

 

Best of luck on de-rusting.

Permalink Reply by Spencer "Thunderball" Thayer! on May 6, 2011 at 11:00am


Wish Ning had a like button.


Tank-Ridin' Ryan said:

Spencer, you must really love cigars to have a humidor big enough to store bikes in it.  Or is that your rain forest reclamation/bike room?

 

Best of luck on de-rusting.

Permalink Reply by Moc Artsy on May 6, 2011 at 4:42pm
For God's sake, Howard, what are you doing with an angle grinder?
Permalink Reply by Allen Wrench on May 6, 2011 at 5:13pm

Had a problem like this and went to my favorite locksmith with the rusted Kryptonite Evolution padlock and cable holding my spare wheel onto the bottom of my car. They cordless angle ground it in less time than it takes to read this reply (slowly) and zipped through heavy cable to help move the wheel out in less than a second. Cost me I think $10. Moral: insure your bike because the lock isn't going to do it.

Permalink Reply by Doug Haynes on May 7, 2011 at 1:39am

Wd-40 has no place being used, well for anything, but sure as hell not a penetrating lube.

 

Try a penetrating lube and/or graphite.

Permalink Reply by Far'arned Retrogrumpalunkus #63 on May 7, 2011 at 3:41am

Marvel Mystery Oil will break just about anything free even though it's not the thinnest penetrant ever devised.  I'm not sure what it is about it but it works great.  I've had engines with stuck rings that nothing else would work and MMO was able to free them right up in a couple of hours.

 

Other options would be PB Blaster or Freeze-off.  Banging on the side of it with a hammer might help free it up after oiling it. 

 

 

Permalink Reply by Far'arned Retrogrumpalunkus #63 on May 7, 2011 at 4:18am

Doesn't everyone own an angle grinder?  Next to a hand drill it's probably one of handiest power tools I have around the house.

 

In fact, I use it so much I almost thought about picking one of these up -but It takes up more room that I don't have. 

RSS

Groups

© 2008-2016   The Chainlink Community, L.L.C.   Powered by

Disclaimer  |  Report an Issue  |  Terms of Service